Mark0's Forum

Software => Plugins => Topic started by: Louis on May 30, 2007, 04:39:49 PM

Title: Unable to read ClamWin config file
Post by: Louis on May 30, 2007, 04:39:49 PM

I've install ClamWin and your Bat plugin.

Problem: When I run the Bat an error message is given saying, "Unable to read ClamWin config file."

When I check the file I find that it is in a read-only folder. I have full admin rights, but when I uncheck read-only in the properties window of the folder, it seems to work, but if I then immediately check again I see that read-only has been put into effect again. The file itself is not read-only. So I am not sure if this is what is causing the problem.

Do you have any idea how I can correct this problem?

Title: Re: Unable to read ClamWin config file
Post by: Louis on May 30, 2007, 06:07:28 PM

Ok, found this: http://www.annoyances.org/exec/forum/winxp/1045053222

So the read only attribute is not the problem. But I still can't use the plugin, as it says it cannot read the ClamWin config file.

What is the solution?

Title: Re: Unable to read ClamWin config file
Post by: Mark0 on May 31, 2007, 10:16:20 PM

Sorry for the late reply - so much things to do, so little time!
Check the message I just posted here: [TBClamWin] The Bat ClamWin plugin (http://www.exe64.com/forum/index.php/topic,16.msg560.html#msg560)

Title: Re: Unable to read ClamWin config file
Post by: Louis on August 08, 2007, 01:46:54 PM

Any chance for an update to your plug-in any time soon?

Title: Re: Unable to read ClamWin config file
Post by: Mark0 on August 11, 2007, 08:45:52 PM

Finally, good news here: Updated: TBClamWin 1.03 (http://www.exe64.com/forum/index.php/topic,88.new.html) :)

Bye!