Unable to read ClamWin config file

[Louis]

I've install ClamWin and your Bat plugin.

Problem: When I run the Bat an error message is given saying, "Unable to read ClamWin config file."

When I check the file I find that it is in a read-only folder. I have full admin rights, but when I uncheck read-only in the properties window of the folder, it seems to work, but if I then immediately check again I see that read-only has been put into effect again. The file itself is not read-only. So I am not sure if this is what is causing the problem.

Do you have any idea how I can correct this problem?

[Louis]

Ok, found this: http://www.annoyances.org/exec/forum/winxp/1045053222

So the read only attribute is not the problem. But I still can't use the plugin, as it says it cannot read the ClamWin config file.

What is the solution?

[Mark0]

Sorry for the late reply - so much things to do, so little time!
Check the message I just posted here: [TBClamWin] The Bat ClamWin plugin

[Louis]

Any chance for an update to your plug-in any time soon?

[Mark0]

Finally, good news here: Updated: TBClamWin 1.03 :)

Bye!